Wegener UNITY4000 Spécifications télécharger pdf (Page 35)

*Closure Map

This allows you to change the relay assignments.

The Relay Specification section lists the different

functions and states. The names are listed in the

illustration to the right. The numbers are the relay

numbers. All six relays can be used if the time sync

and the alarm functions are not used. If they are

used, however, only the first four relays are

available. This section assumes that the alarm (#6)

and time sync (#5) functions are used and only

relays #1-#4 are available.

The Relay Test Menu is only accessible by holding

down the [UP] and [DOWN] at the same time while

in this menu.

General instructions:

1. [ENTER] moves between fields and accepts

changes

2. [BACK] goes to a previous field and saves the setting only when you are on the name of

the relay (P1LS, P1LE, etc.)

3. [UP] and [DOWN] change values

Changing settings:

1. Press [ENTER] to edit the closure map and highlight P1LS

2. Press [ENTER] to move to the relay – this will be 1 in the default settings

3. Press [UP] or [DOWN] to change this to any of the available relays (in the default

setting, only relays #1-#4 are available)

4. Press [ENTER] to move to the state – in the default settings, this will be ON

5. Press [UP] or [DOWN] to change the setting from ON to OFF or PULSE

6. Press [ENTER] to highlight P1LS

7. Press [BACK] to save your setting

Until you press [BACK] you will rotate through the NAME, RELAY and STATE.

To reset the closure map to its default settings, you must enter the Relay Test Menu

(pressing [UP] and [DOWN] at the same time) and then press [UP] and [DOWN] at the

same time while in the Relay Test Menu. The following section describes that procedure.

Rev. 36 – Firmware version 1.61 35

2008

Relay Test Menu - hidden

Closure Map

P2RS

P2RE

B2RS

B2RE

…

P1LS

P1LE

B1LS

B1LE

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 58 59

Commentaires sur ces manuels

Pas de commentaire

Wegener UNITY4000 Spécifications Page 35

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteur Wegener UNITY4000