Wegener Unity 4650 Manuel d'utilisateur télécharger pdf (Page 63)

Unity 4650 User’s Manual

wegener.com 63 800034-01 Rev. A

Expanded U4650 report on unit NV operating parameters. A Local Control

Command (available from the terminal regardless of "Local Control Enable/

Disable" commands from the network).

state [number]

state: O or C meaning Open (ON) or Close (OFF), respectively.

[number]: 1 or 2 (or higher if relay option module installed) indicating the

affected user relay. Both are specified if omitted.

This command sets the user relay addressed by number to the ON/OFF state

specified. Command is non-volatile.

RESET

Resets unit. A Local Control Command (available from the terminal regardless

of "Local Control Enable/Disable" commands from the network).

RPATH

Command to display all return path non-volatile settings. A Local Control

Command (available from the terminal regardless of "Local Control Enable/

Disable" commands from the network). A Local Control Command (available

from the terminal regardless of "Local Control Enable/Disable" commands

from the network).

MSC - Miscellaneous

PRGMP - Program mapping at ASI output

REC - Automated Recovery

RF - Carrier and RF

RPA - Return Path

S - Current Unit (“Perm”) Settings

SER - Serial Ports

SW - Application software maintenance

TS - Transport Stream processing

VID - Video service

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 91 92

Pas de commentaire

Wegener Unity 4650 Manuel d'utilisateur Page 63